Cold exterior walls are among the most common causes of moisture problems in residential and existing buildings. If the surface temperature drops, moisture can condense in the plaster.
Aurawell actively tempers wall surfaces and raises the surface temperature. The aim is to reduce moisture levels in the wall area and significantly mitigate the conditions for mold growth.
On cold wall surfaces, condensation can form in the plaster. This is particularly common in:
The actual size of the room that can be heated depends, among other things, on the insulation standard, the age of the building and the number of exterior walls.
The panels are glued to the wall across their entire surface and are only 5 mm thin.
The heating mat is integrated on the back, allowing heat to be emitted both forward into the room and backward towards the wall.
The adjacent wall surface is actively heated within a radius of approximately 30 cm.
The goal of temperature control is:
This can significantly improve the conditions for mold growth, especially on exterior walls.
Heating panels do not replace structural sealing in the case of rising or permanently penetrating moisture.
In the case of structural causes (e.g., sealing, base area), the cause should generally be remediated beforehand or concurrently.
Aurawell is a solution for active temperature control – not a structural renovation.
Aurawell works primarily with radiant heat, supplemented by gentle warming of the room air.
The heating of the wall surfaces ensures a stable, even indoor climate.
The system significantly reduces the sensation of cold air on exterior walls.
Electricity consumption can be measured directly via an electricity meter at the socket.
The panel is glued directly to the wall. No water systems, floor openings, or complex structural alterations are required.
The construction is only 5 mm thin and fully bonded. This makes the system particularly suitable for:
By actively tempering cold exterior walls, the surface temperature can be specifically increased.
Does the panel replace mold remediation?
No. If the moisture is caused by structural issues, the underlying cause must be remediated.
Is the wall behind the panel also heated?
Yes. Heat is also emitted to the rear, towards the wall.
For which areas is the solution particularly suitable?
Aurawell is ideally suited for cold exterior walls and living areas with moisture exposure.
